Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Mazda MPV LXFACTORY OEM SERVICE PROCEDURE

Transaxle Installation Note

WARNING:

Verify that the transaxle is securely supported by the jack. If the transaxle should falls, serious injury or death and damage to the vehicle could result. Before removing the transaxle make sure that the jack is securely supporting it.

Set the transaxle on a jack and lift it into place.

Fig 1: Setting Transaxle On Jack
Courtesy of MAZDA MOTORS CORP.
Install the transaxle mounting bolts.
Tightening torque

37-52 N.m {3.8-5.3 kgf.m, 28-38 ft.lbf}

Fig 2: Identifying Transaxle Mounting Bolts
Courtesy of MAZDA MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.