2003 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Transaxle Removal Note

  1. Loosen the SSTs  (engine support) and lean the engine toward the transaxle.
    WARNING:
    • Verify that the transaxle is securely supported by the jack. If the transaxle falls, serious injury or death and damage to the vehicle could result. Before removing the transaxle make sure that the jack is securely supporting it.
      Fig 1: Loosening SSTs (Engine Support)
      G01883452Courtesy of MAZDA MOTORS CORP.
  2. Support the transaxle on a jack.
    Fig 2: Supporting Transaxle On Jack
    G01883453Courtesy of MAZDA MOTORS CORP.
  3. Remove the transaxle mounting bolts.
  4. Remove the transaxle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.