2003 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Mode 6 - EVAP System Repair Verification Drive Mode

NOTE: If EVAP System Repair Verification Drive Mode cannot be performed because vehicle cannot be driven under conditions specified for this test, perform evaporative system test procedure as an alternative. See FUEL EVAPORATIVE SYSTEM (MPV) under EMISSION SYSTEMS & SUB-SYSTEMS in SYSTEM & COMPONENT TESTING - MAZDA6, MIATA, MPV, PROTEGE & PROTEGE5 article. Mode 6 can be performed regardless of RFCFLAG condition.
  1. Ensure following PIDs are within following specifications:
    • BARO: 21.3 in. Hg (72.3 kPa)
    • FTL: .5-2.5 volts
    • IAT: 41-95°F (5-35°C)
    • VPWR: 10.9-14.6 volts

    All PIDs must be within specification before engine is started to initiate evaporative emission test. Go to next step.

  2. Using scan tool, clear DTCs from memory. See CLEARING DIAGNOSTIC TROUBLE CODES . Start engine and allow to idle for more than 10 seconds. Turn ignition off. Wait for 5 hours or more.
  3. Start engine and increase RPM to 3500 to warm up to normal operating temperature. Allow engine to idle for more than 15 minutes. Drive vehicle at 40-50 MPH for more than 5 minutes. Stop vehicle and turn ignition off. Wait 20 minutes or more. Start engine. Access ON BOARD SYSTEM READINESS menu of GENERIC OBD II FUNCTIONS to check Drive Mode completion status. Test is complete when Readiness Function Check (RFC) flag changes from NO to YES. Go to next step. If test is not complete, turn ignition off and go back to step  1.
  4. Access DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD II FUNCTIONS. If MEAS are within specification, ensure DTCs are not present. If DTCs are not present, repairs are complete. If MEAS are not within specification, repairs are not complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.