Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE
Instrumentation/Driver Info
- Instrument Cluster System Wiring Diagram
- Instrument Cluster Removal/Installation
- Instrument Cluster Disassembly/Assembly
- Instrument Cluster Inspection
- Instrument Cluster Repair
- Instrument Cluster Input/Output Check Mode
- Notes
- Diagnostic Trouble Code Chart
- Operating Order
- Checking Order
- Diagnostic Trouble Code Definitions
- Inspection of Diagnostic Trouble Codes
- DTC 01: Buckle Switch On/Off Signal
- DTC 04: Door Switch On/Off Signal
- DTC 05: Door Lock-Link Switch On/Off Signal
- DTC 07: Rear Window Defroster Switch On/Off Signal
- DTC 08: TNS Relay On/Off Signal
- DTC 10: Vehicle Speed Input Signal
- DTC 11: Engine Speed Input Signal
- DTC 12: Operation Signal To Speedometer
- DTC 13: Operation Signal To Tachometer
- DTC 14: Operation Signal To Buzzer
- DTC 16: Operation Signal To Fuel-Level Warning Light
- DTC 17: Operation Signal To Rear Window Defroster Indicator Light
- DTC 18: Ignition Key Illumination On/Off Signal
- DTC 20: Operation Signal To Rear Window Defroster Relay On/Off Signal
- DTC 22: Fuel Level Signal
- DTC 23: Operation Signal To Fuel Gauge
- DTC 24: Water Temperature Signal
- DTC 25: Operation Signal To Water Temperature Gauge
- DTC 26: LCD Indication
- DTC 27: Operation Signal To Interior Light
- DTC 31: Key Reminder On/Off Signal
- DTC 41: P Position Switch On/Off Signal
- DTC 42: Operation Signal To Interlock Solenoid
- Warning And Indicator Light Bulb Removal/Installation
- Fuel Gauge Sender Unit Inspection
- Oil Pressure Switch Inspection
- Horn Removal/Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.