NOTE: Since the charging current decreases rapidly after starting the engine, carry out the following procedure quickly, and read the maximum current value.

Verify that the battery is fully charged.
Verify that the drive belt deflection/tension is correct.
Disconnect the negative battery cable.
Connect a tester capable of reading 120 amps or above, between generator terminal "B" and the wiring harness connector.
Connect the negative battery cable.
Turn off all electrical loads. Start the engine. Increase engine speed to 2000-2500 RPM.

NOTE: Current required for generating power varies with electrical loads applied.

Turn headlights (high-beam), blower motor (high), rear window defroster and brake lights on and verify that the current reading increases. If generator terminal "B" current does not increase, repair or replace the generator if necessary.
Standard current (reference) See GENERATOR AMPERAGE table.
Measuring conditions:
- Room temperature: 68°F (20°C).
- Voltage: 13.5 volts.
- Engine hot.

GENERATOR AMPERAGE

Terminal "B" @ 1000 RPM - Amps

Terminal "B" @ 2000 RPM - Amps

⁽¹⁾ 0-90

⁽¹⁾ 0-105

⁽¹⁾	Lower limit of current must be more than zero amps.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Generator Current

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?