Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE
Power Outside Mirror Removal/Installation
- Disconnect the negative battery cable.
- Remove the inner garnish.
- Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
- Partially peel off the door screen.
- Disconnect the connector.
- Remove the nuts, and then remove the power outside mirror.
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.