2003 Mazda B2300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Door Glass Front Removal/Installation: Notes

NOTE:
  • Position the door glass half-way up to gain access to the rivets.
  1. Remove the front door trim panel and watershield; see DOOR TRIM PANEL FRONT REMOVAL/INSTALLATION
  2. Remove in order shown in figure
    1. Bolt
    2. Door glass run retainer
    3. Rivets
    4. Door glass
    Fig 1: Removing/Installing Front Door Glass
    G01925833Courtesy of MAZDA MOTORS CORP.
  3. Install in reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.