Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Mazda 6 s, AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications: 2004

GENERATOR TORQUE SPECIFICATIONS

Application

Ft. Lbs. (N.m)

Generator Mounting Bolts

29-41 (40-50)

Pulley Nut

⁽¹⁾ 72-94 (98-137)

Terminal "B+" Wire Nut

8-10 (9.9-14.7)

⁽¹⁾	On 2.3L with A/T, pulley is pressed on using SST 49 L018 O02, or equivalent, tightend to 42-62 ft. lbs. 61-84 N.m).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.