Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mazda 6 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Emission Control Systems: Technical Service Bulletins
- Recalls
- Customer Interest
- By Symptom
- All Technical Service Bulletins
- Campaign - Warranty Information Booklet Update
- Dealer Letter
- Model Year 2000 California Emission Control Warranty
- Model Year 2001 California Emission Control Warranty
- Model Year 2002 California Emission Control Warranty
- Model Year 2003 California Emission Control Warranty
- Model Year 2004 California Emission Control Warranty
- Model Year 2005 California Emission Control Warranty
- Model Year 2006 California Emission Control Warranty
- Model Year 2007 California Emission Control Warranty
- Model Year 2008 California Emission Control Warranty
- Model Year 2009 California Emission Control Warranty
- Reimbursement Plan
- Reimbursement Form
- Owner Letter
- Emissions - MIL ON/DTC's P0441/P0442/P0455/P0456 Set
- Recall - PCM/TCM Reprogramming for I/M Failure
- Recall - PCM Reprogramming for MIL/DTC P2404
- Emissions - MIL ON, DTC P2227 Set
- Engine Controls/Emissions - MIL ON/DTC's P2404/P0456
- Exhaust System - Rubbing Noise At Idle
- Exhaust System - Excessive Sulfur Odors
- Campaign - Warranty Information Booklet Update
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
