Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mazda 6 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Variable Valve Timing Actuator: Service and Repair
VARIABLE VALVE TIMING ACTUATOR REMOVAL/INSTALLATION
Caution
^ The variable valve timing actuator cannot be disassembled because it is a precision unit.
Note
^ The variable valve timing actuator camshaft sprocket is integrated with the variable valve timing actuator and cannot be disassembled.
1. Follow the timing chain removal/installation procedure from 1 to 12 and remove the timing chain.

2. Remove the variable valve timing actuator.
1) Set a wrench or equivalent tool at the hexagonal part of the camshaft to prevent rotation.
2) Loosen the variable valve timing actuator tightening bolt.
3. Install the variable valve timing actuator.
1) Set a wrench or equivalent tool at the hexagonal part of the camshaft to prevent rotation.
2) Tighten the variable valve timing actuator tightening bolt.
Tightening torque 69 - 75 Nm (7.1 - 7.6 kgf-cm, 50.9 - 55.3 ft. lbs.)
Caution
^ The variable valve timing actuator cannot be disassembled because it is a precision unit.
Note
^ The variable valve timing actuator camshaft sprocket is integrated with the variable valve timing actuator and cannot be disassembled.
1. Follow the timing chain removal/installation procedure from 1 to 12 and remove the timing chain.
2. Remove the variable valve timing actuator.
1) Set a wrench or equivalent tool at the hexagonal part of the camshaft to prevent rotation.
2) Loosen the variable valve timing actuator tightening bolt.
3. Install the variable valve timing actuator.
1) Set a wrench or equivalent tool at the hexagonal part of the camshaft to prevent rotation.
2) Tighten the variable valve timing actuator tightening bolt.
Tightening torque 69 - 75 Nm (7.1 - 7.6 kgf-cm, 50.9 - 55.3 ft. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
