2003 Mazda 6 L4-2.3LFACTORY OEM SERVICE PROCEDURE

Fuse: Service and Repair

MAIN FUSE REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the main fuse block cover.

Factory service manual diagram



Factory service manual diagram



3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.

Bolt Removal Note

Factory service manual diagram



1. Press and remove the tabs on the main fuse block at the positions indicated by the arrows.

Factory service manual diagram



2. Lift up the main fuse block and remove the bolts
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.