Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mazda Tribute DX 2WD L4-2.0LFACTORY OEM SERVICE PROCEDURE
Throttle Position Sensor: Service and Repair
Removal and Installation
NOTE: 3.0L is shown. 2.0L is similar.
1. Remove the nuts and the engine appearance cover(3.0L).
NOTE: Air cleaner outlet tube is removed for clarity.
2. Remove the throttle position (TP) sensor.
1. Disconnect the electrical connector.
2. Remove the screws.
3. Remove the sensor
3. To install, reverse the removal procedure.
NOTE: 3.0L is shown. 2.0L is similar.
1. Remove the nuts and the engine appearance cover(3.0L).
NOTE: Air cleaner outlet tube is removed for clarity.
2. Remove the throttle position (TP) sensor.
1. Disconnect the electrical connector.
2. Remove the screws.
3. Remove the sensor
3. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.