Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
On-Board System Readiness Test Mode
On-Board System Readiness (OSR) test mode indicates OBD II system operating status. World Diagnostic System (WDS) or equivalent scan tool will determine which monitored function has not been completed. Misfires, fuel system and comprehensive components are continuous monitoring-type functions. Catalyst, EGR system, EVAP system and oxygen sensor are monitored during each drive cycles (modes). See DRIVE MODESΒ . To access OSR, perform following procedure:
- Apply parking brake. Place shift lever in Park (A/T) or Neutral (M/T). Block wheels. Turn off all electrical accessories. Ensure engine is at normal operating temperature.
- Perform visual inspection. Ensure air cleaner and inlet ducts are clean, and system wiring harness is properly connected. Check for bent or broken connector terminals and corroded or loose wires. Check PCM, sensors and actuators for physical damage. Check engine coolant for proper level and mixture. Check for proper transmission fluid level and quality.
- Turn ignition switch off. Connect scan tool to DLC-2 located at left side of steering column, under instrument panel. Follow scan tool manufacturer's operating instructions to connect equipment and operate on-board readiness test.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
