Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mazda Millenia PFACTORY OEM SERVICE PROCEDURE
Radiator Removal/Installation
WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
- Remove the air cleaner. (See L3: INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3] , AJ: INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [AJ] .)
- Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION .)
- Remove the cooling fan. (See COOLING FAN REMOVAL/INSTALLATION .)
- Disconnect the upper radiator hose from the radiator. (L3 engine model)
- Disconnect the oil hose from the radiator. (ATX)
- Remove the coolant reservoir hose. (AJ engine model)
- Remove in the order indicated in Fig 1.
- Install in the reverse order of the removal.
- Add the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
- Inspect the engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION .)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
