Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mazda Millenia PFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Definitions
DIAGNOSTIC TROUBLE CODE DEFINITIONS
| DTC | System Affected | ||||||||
|---|---|---|---|---|---|---|---|---|---|
| P0100 | MAF Circuit Malfunction | ||||||||
| P0110 | IAT Circuit Malfunction | ||||||||
| P0115 | Engine Coolant Temperature (ECT) Circuit Malfunction | ||||||||
| P0120 (1) | Throttle Position (TP) Circuit Malfunction | ||||||||
| P0125 | Insufficient Coolant Temperature For Closed Loop Fuel Control | ||||||||
| P0130 | Right Front HO2S Circuit Malfunction | ||||||||
| P0134 | Right Front HO2S Circuit, No Activity Detected | ||||||||
| P0135 | Right Front HO2S Heater Circuit Malfunction | ||||||||
| P0138 | Right Rear HO2S Circuit, High Input | ||||||||
| P0141 | Right Rear HO2S Heater Circuit Malfunction | ||||||||
| P0155 | Left Front HO2S Heater Circuit Malfunction | ||||||||
| P0158 | Left Rear Circuit, High Input | ||||||||
| P0161 | Left Rear HO2S Heater Circuit Malfunction | ||||||||
| P0170 | Right Bank Fuel Trim Malfunction | ||||||||
| P0173 | Left Bank Fuel Trim Malfunction | ||||||||
| P0300 (2) | Random Misfire Detected | ||||||||
| P0301 (2) | Cylinder No. 1 Misfire Detected | ||||||||
| P0302 (2) | Cylinder No. 2 Misfire Detected | ||||||||
| P0303 (2) | Cylinder No. 3 Misfire Detected | ||||||||
| P0304 (2) | Cylinder No. 4 Misfire Detected | ||||||||
| P0305 (2) | Cylinder No. 5 Misfire Detected | ||||||||
| P0306 (2) | Cylinder No. 6 Misfire Detected | ||||||||
| P0325 | Knock Sensor Circuit Malfunction | ||||||||
| P0335 (1) | CKP Sensor Circuit Malfunction | ||||||||
| P0400 | EGR System Malfunction | ||||||||
| P0404 | EGR Circuit, Range/Performance Problem | ||||||||
| P0421 | Right Bank Warm-Up Catalyst System Efficiency Below Threshold | ||||||||
| P0431 | Left Bank Warm-Up Catalyst System Efficiency Below Threshold | ||||||||
| P0442 | EVAP Control System, Small Leak Detected | ||||||||
| P0450 | Fuel Tank Pressure Sensor Circuit Malfunction | ||||||||
| P0451 | Fuel Tank Pressure Sensor, Performance Problem | ||||||||
| P0455 | EVAP Control System, Excessive Leak Or Blockage Detected | ||||||||
| P0464 | Fuel Gauge Sending Unit Circuit, Slosh Check | ||||||||
| P0480 (3) | Condenser Fan Relay No. 1 Circuit Malfunction | ||||||||
| P0481 (3) | Cooling Fan Relay & Condenser Fan Relay No. 2 Circuit Malfunction | ||||||||
| P0482 (3) | Cooling Fan Relay & Condenser Fan Relay No. 2 Circuit Malfunction | ||||||||
| P0505 | Idle Air Control System Malfunction | ||||||||
| P0550 | Power Steering Pressure Switch Circuit Malfunction | ||||||||
| P0703 | Brake Switch Circuit Malfunction | ||||||||
| P0705 (4) | Transaxle Range Switch Circuit Malfunction (Short Circuit) | ||||||||
| P0706 (4) | Transaxle Range Switch Circuit Malfunction (Open Circuit) | ||||||||
| P0710 (4) | Transaxle Fluid Temperature Sensor Circuit Malfunction (Short To Ground/Open Circuit) | ||||||||
| P0711 (4) | Transaxle Fluid Temperature Sensor Circuit Malfunction (Stuck) | ||||||||
| P0715 (4) | Input/Turbine Speed Sensor Circuit Malfunction | ||||||||
| P0731 (4) | Gear 1 Incorrect Ratio | ||||||||
| P0732 (4) | Gear 2 Incorrect Ratio | ||||||||
| P0733 (4) | Gear 3 Incorrect Ratio | ||||||||
| P0734 (4) | Gear 4 Incorrect Ratio | ||||||||
| P0740 (4) | Torque Convertor Clutch (TCC) System Malfunction | ||||||||
| P0745 (4) | Pressure Control Solenoid Circuit Malfunction | ||||||||
| P0750 (4) | Shift Solenoid "A" Circuit Malfunction | ||||||||
| P0755 (4) | Shift Solenoid "B" Circuit Malfunction | ||||||||
| P0760 (4) | Shift Solenoid "C" Circuit Malfunction | ||||||||
| P1170 | Right Front HO2S, No Inversion | ||||||||
| P1195 | BARO Circuit Malfunction | ||||||||
| P1196 | Starter Signal Circuit Malfunction | ||||||||
| P1250 (3) | PRC Solenoid Valve Circuit Malfunction | ||||||||
| P1345 | CMP Sensor Circuit Malfunction | ||||||||
| P1402 | EGR Valve Position Sensor Circuit Malfunction | ||||||||
| P1450 | EVAP Control System Malfunction, Excessive Vacuum | ||||||||
| P1455 | Fuel Gauge Sender Unit Circuit Malfunction | ||||||||
| P1521 (3) | Variable Resonance Induction System (VRIS) Solenoid Valve No. 1 Circuit Malfunction | ||||||||
| P1522 (3) | Variable Resonance Induction System (VRIS) Solenoid Valve No. 2 Circuit Malfunction | ||||||||
| P1609 | PCM Internal Malfunction | ||||||||
| P1627 | Powertrain Control Module (PCM) - Anti-Lock Brake System (ABS)/Traction Control System (TCS) Line Communication Error | ||||||||
| P1743 (4) | Torque Convertor Clutch (TCC) Control Solenoid Valve Circuit Malfunction | ||||||||
| P1765 (4) | 3-2 Timing Solenoid Valve Circuit Malfunction | ||||||||
| P1794 | PCM +BB Voltage Low | ||||||||
|
|||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
