2002 Mazda MX-5 Miata Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Pre-Inspection

  1. Inspect the tire inflation, and adjust to the recommended pressure as necessary.
  2. Inspect the front wheel bearing play and correct as necessary.
  3. Inspect the wheel and tire runouts.
  4. Inspect the ball joints and steering linkage for excessive looseness.
  5. The vehicle must be on level ground and carry no luggage or passengers.
  6. Measure the height from the center of the wheel to the fender brim. The difference between the left and right measurement must not exceed 10 mm {0.39 in}.Β 
    Fig 1: Measuring Height From Center Of Wheel To Fender Brim
    G01907053Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.