2002 Mazda MX-5 Miata Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Starter Mounting Bolts
Step 1 - Fitting Bolt "A" (1)
Step 2 - Fitting Bolts "B" & "C" 32-44 (44-60)
Step 3 - Fitting Bolt "A" 32-44 (44-60)
INCH Lbs. (N.m)Β 
Battery Cable Nuts 87-104 (9.9 - 11.7)
Magnetic Switch Mounting Bolt 37-67 (4.1-7.6)
Rear Housing Long Bolt 38-62 (4.4-7.0
Rear Housing Short Bolt 21-39 (2.4-4.4)
(1) Temporarily tighten starter fitting bolt "A". See Fig 1 .
Fig 1: Installing Starter
G00356727Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.