2002 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Caster Adjustment

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Adjust the caster after adjusting the camber.
  1. Loosen the installation nut of the adjusting cam bolt (front lower arm rear side).
    Fig 1: Locating Front Wheel Adjusting Cam Bolt
    G01346410Courtesy of MAZDA MOTORS CORP.
  2. Rotate the adjusting cam bolt in either direction to adjust the caster.

    Standard Suspension 

    Fig 2: Front Wheel Standard Caster
    G01346411Courtesy of MAZDA MOTORS CORP.

    Sport Suspension 

    Fig 3: Sport Suspension Front Wheel Caster
    G01346412Courtesy of MAZDA MOTORS CORP.
Chapter Navigation
Return to Chapter: Front Wheel Alignment
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.