Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Combination Switch Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE .
Remove the steering wheel. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION .)
Remove the clock spring.

Remove in the order indicated in the table/figure.

REMOVING/INSTALLING COMBINATION SWITCH ⁽¹⁾

Component/Step No.

Component Description

Connector

Screw

Combination switch

⁽¹⁾	See Fig 1.

Fig 1: Removing/Installing Combination Switch

Courtesy of MAZDA MOTORS CORP.

Install in the reverse order of removal.

Chapter Navigation

Return to Chapter: Section 173 (Lighting System)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.