2002 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Fuel Pump Relay: MPV

Remove fuel pump relay. See FUEL PUMP RELAY LOCATIONSΒ  table. Using ohmmeter, check for continuity between relay terminals "C" and "D". See Fig 1 . Continuity should not be present. Using fused jumper wires apply battery voltage to terminal "A" and ground terminal "E". Continuity should be present between fuel pump relay terminals "C" and "D" with battery voltage applied. If continuity is not as specified, replace fuel pump relay.

Fig 1: Identifying Fuel Pump Relay Terminals (MPV)
G00110080Courtesy of MAZDA MOTORS CORP.
FUEL PUMP RELAY LOCATIONS

Application Location
Miata Under Left Side Of Dash, Above Left Kick Panel
Millenia 2.3L Left Front Of Engine Compartment, Mounted Near Cruise Actuator
Millenia 2.5L Fuse/Relay Box On Left Side Of Engine Compartment
MPV Fuse/Relay Box On Left Side Of Engine Compartment
Protege & Protege5 Fuse/Relay Box On Left Side Of Engine Compartment
626 Fuse/Relay Box On Left Side Of Engine Compartment
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.