2002 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Knock Sensor: MPV

Disconnect Knock Sensor (KS) connector. Using ohmmeter, measure resistance between KS terminals "A" (Red wire) and "B" (Black wire). Resistance should be about 560,000 ohms at 68Β°F (20Β°C). If resistance is not as specified, replace KS. If KS is within specification, check for open or short circuit in wiring harness. Disconnect PCM and install 104-Pin Breakout Box (49-UN01-130) between PCM and PCM harness connector. See Figure . Perform following circuit inspections:

  • Open Circuit Inspection

    Check for continuity between KS terminal "A" (Blue/White wire) and breakout box terminal No. 57 and between KS terminal "B" (Red/White wire) and breakout box terminal No. 4. If continuity is not present, repair or replace open wiring harness as necessary.
  • Short Circuit Inspection

    Check for continuity between KS terminals "A" or "B" and power and between KS terminals "A" or "B" and ground. If continuity is present, repair or replace shorted wiring harness as necessary.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.