2002 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Detection Condition

PCM monitors Mass Airflow (MAF) sensor input with throttle valve opening and engine speed. If input readings are not consistent with predetermined inputs, DTC is set. If mass airflow is less than 8.93 gram/sec. for 5 seconds and throttle opening is more than 50 percent with engine idling, mass airflow amount is to low. If mass airflow is more than 103 gram/sec. for 5 seconds and engine speed is less than 2000 RPM, mass airflow amount is to high. This is a continuous monitor. MIL is illuminated if PCM detects malfunction in 2 consecutive drive cycles.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.