2002 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Removal & Installation (Millenia 2.3L)

Each ignition coil has an integral control module. To remove coil(s) on front cylinder head, remove Charge Air Cooler (CAC). To remove coil(s) on rear cylinder head, remove solenoid bracket. On all coils, disconnect 4-pin harness connector. Remove mounting bolt and coil assembly. To install, reverse removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.