Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE
Rear Power Window Regulator Removal/Installation
- Disconnect the negative battery cable.
- Remove the rear door glass. See REAR DOOR GLASS AND GUIDE REMOVAL/INSTALLATION .
- Disconnect the rear power window regulator.
- Remove the nuts, then remove the rear power window regulator.
Tightening torque
6.87-9.80 N.m {70-100 kgf.cm, 60.8-86.7 in.lbf}
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.