Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Theft Deterrent Control Module
Locate theft deterrent control module under left side of dash. Remove theft deterrent control module from bracket without disconnecting connectors. Measure voltages by backprobing terminals in connectors as indicated. Disconnect theft deterrent control module connectors before checking continuity at terminals B, N, O, P and T. If voltage measurements and continuity checks are not as specified, check component and wiring. If component and wiring are okay, replace theft deterrent control module. See THEFT DETERRENT CONTROL MODULEΒ under REMOVAL & INSTALLATION.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
