Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mazda B4000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Shift Interlock & Ignition Relay
NOTE:
For circuit reference, see CONNECTOR IDENTIFICATIONΒ
and WIRING DIAGRAMSΒ
. For identification of circuits related to this system, but not shown, see appropriate POWER DISTRIBUTION article in WIRING SYSTEM under ACCESSORIES & EQUIPMENT.
- Check for continuity between terminal No. 85 and all other terminals. For terminal identification, see Figure . If resistance is 5 ohms or less between terminal No. 85 and any other terminal, replace relay. If resistance is greater than 5 ohms, continue with test.
- Using two jumper wires, connect relay terminals No. 86 and 30 directly to the positive battery terminal. Check for voltage at terminal No. 87A. If battery voltage is not indicated, replace the relay. If battery voltage is indicated, connect a third jumper wire to terminal No. 85, and ground the jumper wire to a known good ground. Check for voltage at terminal No. 87. If battery voltage is not indicated, replace the relay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
