2002 Mazda B4000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Steering Column Disassembly/Assembly: Disassembly

  1. Remove the ignition switch lock cylinder. See LOCK CYLINDER REMOVAL/INSTALLATION .
  2. Remove the air bag sliding contact. See CLOCKSPRING .
  3. Remove the steering column. See STEERING COLUMN REMOVAL/INSTALLATION .
  4. On manual transmission equipped vehicles, remove the ignition switch.
    1. Remove the ignition switch bolts.
    2. Remove the ignition switch.
    Fig 1: Removing Ignition Switch
    G02673317Courtesy of MAZDA MOTORS CORP.
  5. Remove the bearing retainer.
    Fig 2: Removing Bearing Retainer
    G02673318Courtesy of MAZDA MOTORS CORP.
  6. Remove the steering column lock housing bearing.
    Fig 3: Removing Steering Column Lock Housing Bearing
    G02673319Courtesy of MAZDA MOTORS CORP.
  7. Remove the steering column lock gear.
    Fig 4: Removing Steering Column Lock Gear
    G02673320Courtesy of MAZDA MOTORS CORP.
  8. On automatic transmission equipped vehicles, remove the shock absorber electronic steering sensor.
    1. Disconnect the electrical connector.
    2. Remove the screws.
    3. Remove the shock absorber electronic steering sensor.
    Fig 5: Removing Shock Absorber Electronic Steering Sensor
    G02673321Courtesy of MAZDA MOTORS CORP.
  9. On fixed steering column equipped vehicles, remove the snap ring from the bottom of the steering column shaft.
    Fig 6: Removing Snap Ring From Bottom Of The Steering Column Shaft
    G02673322Courtesy of MAZDA MOTORS CORP.
  10. On tilt steering column equipped vehicles, remove the sensor ring.
    1. Remove the steering column lower bearing spring.
    2. Remove the sensor ring.
    Fig 7: Removing Sensor Ring
    G02673323Courtesy of MAZDA MOTORS CORP.
  11. Remove the steering column bearing tolerance ring from the steering column shaft.
    Fig 8: Removing Steering Column Bearing Tolerance Ring
    G02673324Courtesy of MAZDA MOTORS CORP.
  12. On tilt steering column equipped vehicles, remove the lock cylinder housing pivot screws.
    Fig 9: Removing Lock Cylinder Housing Pivot Screws
    G02673325Courtesy of MAZDA MOTORS CORP.
    13. WARNING: The steering column position spring is under tension and may come out with great force.
Chapter Navigation
Return to Chapter: Steering Column Disassembly/Assembly
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.