Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Mazda B4000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Key Release Button Removal/Installation

Disconnect the negative battery cable.
Remove the ignition switch lock cylinder. See LOCK CYLINDER REMOVAL/INSTALLATION .
If equipped/remove the tilt wheel handle.

Fig 1: Removing Tilt Wheel Handle
Courtesy of MAZDA MOTORS CORP.
Remove the upper and lower steering column shrouds.
1. Remove screws.
2. Remove shrouds.
Fig 2: Removing Upper & Lower Steering Column Shrouds
Courtesy of MAZDA MOTORS CORP.
Remove the key release lever bolt (1), lever (2) and spring (3).

Fig 3: Removing Key Release Lever
Courtesy of MAZDA MOTORS CORP.
Install in reverse order of removal.

Chapter Navigation

Return to Chapter: Power Steering

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.