Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mazda B4000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Four... Wheel Drive Control Module Connector End View (C281b)
| Pin | Circuit | Circuit function |
|---|---|---|
| 1 | 435 (YE/LB) | signal, return |
| 2 | 570 (BK/WH) | Ground |
| 3 | ... | not used |
| 4 | 762 (YE/WH) | Motor position 1 |
| 5 | ... | not used |
| 6 | 783 (GY) | Four... wheel drive, indicator, High |
| 7 | 764 (BN/WH) | Motor position 3 |
| 8 | ... | not used |
| 9 | 784 (LB/BK) | Four... wheel drive, indicator, Low |
| 10 | ... | not used |
| 11 | ... | not used |
| 12 | 679 (GY/BK) | Vehicle Speed Sensor (VSS), input |
| 13 | 763 (OG/WH) | Motor position 2 |
| 14 | ... | not used |
| 15 | ... | not used |
| 16 | 640 (RD/YE) | Voltage supplied in Start and Run (overload protected) |
| 17 | ... | not used |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.