2002 Mazda B2300 AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Component Location
Clutch Triple Function Switch Jumper (A/T) Behind dash, left of steering column.
Data Link Connector (DLC) Fastened to bottom of dash, near steering column.
Electronic Thermostat (2.3L) On front of engine. See Figure .
Engine Block Heater Element (4.0L) Below exhaust manifold.
Heater Blower Motor Resistor (Front) (4.0L) Right rear of engine compartment, near blower motor.
Ignition Coil (2.3L) On top right side of engine. See Figure .
Ignition Coil (3.0L) On rear of engine. See Figure .
Ignition Coil (4.0L) On left rear of engine. See Figure .
Ignition Transformer Capacitor 1 (4.0L) On top right rear of engine.
PCM Module Power Diode In battery junction box.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.