Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Retrieving Continuous DTCS
Turn ignition switch to LOCK position. Connect New Generation Star (NGS) tester to data link connector. Enter vehicle information on NGS tester. Select DIAGNOSTIC DATA LINK TEST, then select GEM - GENERIC ELECTRONIC MODULE on NGS tester. Enter appropriate vehicle options on NGS tester. After all vehicle options are selected, press SAVE key. Select DIAGNOSTIC TEST MODE. Select RETRIEVE/CLEAR CONTINUOUS DTCs. Record all DTCs. See GENERIC ELECTRONIC MODULE (GEM) DTC INDEX table.
| DTC | Description | Perform Test No. (1) | ||||
|---|---|---|---|---|---|---|
| B1342 | GEM Defective | (2) | ||||
| B1398 | Power Window One-Touch Relay Circuit Failure | 2 & 4 | ||||
| B1400 | Power Window One-Touch Relay Coil Circuit Short To Power | 2 & 4 | ||||
| B1404 | Left Power Window Down Switch Input Circuit Failure | 2 | ||||
| B1405 | Left Power Window Down Switch Short Circuit To Power | 2 | ||||
| B1410 | Left Power Window Motor Circuit Failure | 2 | ||||
|
||||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
