Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mazda 626 ES, AutomaticFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System: Outline
- The ABS is an electronically controlled brake system which controls brake application to maintain directional stability and steering of the vehicle during braking.
- The ABS does this by determining the amount of wheel slippage during sudden braking or during braking on snow-covered or otherwise slippery road surfaces. Signals are then relayed and acted upon through a computerized ABS control module.
- The ABS is an independent front wheel control, rear axle control (select low control), four sensor, 3-channel system.
- It's basic components are the hydraulic unit, the control module and the four wheel-speed sensors.
NOTE:
- Select low control is a method that controls the hydraulic pressure of both the right and left rear wheels by comparing wheel speeds and then controlling the hydraulic pressure in relation to the side which is in greater danger of the brake locking.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
