2001 Mazda Tribute ES, FWDFACTORY OEM SERVICE PROCEDURE

Transaxle Range (Tr) Sensor: Installation

NOTE: Make sure the transaxle is in the NEUTRAL position.
  1. Install the transaxle range (TR) sensor and loosely install the bolts.
    Fig 1: Install The Transaxle Range Sensor
    G01163259
  2. Using the special tool, align the TR sensor and tighten the bolts.
    1. Connect the electrical connector.
    Fig 2: Connecting The Electrical Connector
    G01163260
  3. Install the thermostat housing.
  4. Install the air cleaner assembly.
    Fig 3: Installing Air Cleaner Assembly
    G01163261
  5. Install the intake tube and air cleaner cover.
    Fig 4: Installing Intake Tube And Air Cleaner Cover
    G01163262
  6. Connect the breather tube and mass air flow (MAF) / intake air temperature (IAT) sensor.
    NOTE: Before installing the battery tray check the vent tube hose for any obstructions, kinks, or incorrect routing position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.