Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE
Combination Switch: Installation
- To install, reverse removal procedure. Ensure front wheels are in straight-ahead position. Before installing steering wheel, center clockspring. See CLOCKSPRING CENTERING under ADJUSTMENTS. Tighten steering wheel nut to specification. See TORQUE SPECIFICATIONS .
- After installation, activate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK under DISABLING & ACTIVATING AIR BAG SYSTEM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
