Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE
Generator Warning Light
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the battery is fully charged.
- Charge if necessary.
- Verify that the drive belt deflection/tension is within the specification. (See DRIVE BELT INSPECTION
.)
- Adjust if necessary.
- Turn the ignition switch on and verify that the generator warning light comes on.
- If the warning light does not illuminate, inspect the harness from ignition switch to generator warning light and from generator warning light to 3U terminal of PCM. If the generator warning light and harnesses are normal, replace the PCM.
- Confirm that the generator warning light goes off after starting the engine.
- If the generator warning light does not go off, inspect the on-board diagnostic system service code. (See ENGINE CONTROL SYSTEM OPERATION INSPECTION [BP, BP WITH TC] .)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.