Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE
Intake Manifold Vacuum Inspection
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Verify air intake hoses are installed properly.
- Start the engine and run it at idle.
- Disconnect the vacuum hose between the intake manifold and purge solenoid valve from the intake manifold side.
- Connect a vacuum gauge to the intake manifold and measure the intake manifold vacuum.
- If not as specified, inspect the following:
- Air suction at throttle body and intake manifold installation points
- Fuel injector insulator
- Engine compression
- If not as specified, inspect the following:
Specification
MT: -66.7-56.0 kPa {-500.24-420.1 mm Hg, -19.6-16.6 in Hg}
AT: -67.3-53.4kPa {-504.7-400.6 mm Hg, -19.8-15.8 in Hg}
NOTE:
- Air suction can be located by engine speed change when lubricant is sprayed on the area where suction is occurring.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.