2001 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE

Load Compensation Inspection

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start the engine and run it at idle.
  2. Connect the WDS or equivalent to the DLC-2.
  3. Verify that P0506 or P0507 is not displayed.
    • If P0506 or P0507 are displayed, perform DTC inspection (See DTC TABLES .)
  4. Select the RPM PID.
    NOTE:
    • Excludes temporary idle speed drop just after the loads are turned on.
  5. Verify that the engine speed is within the specification under each load condition.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.