2001 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE

Fuel Injector Volume - Miata

  1. Disconnect battery. Remove fuel rail assembly and injectors from intake manifold. See REMOVAL, OVERHAUL & INSTALLATION article.
  2. Using mechanics wire, secure each fuel injector to fuel rail. Disconnect fuel injector connectors. Reconnect fuel lines to fuel rail.
  3. Using Service tool (49L018901), connect battery to each injector in turn. Using a fused jumper wire, connect DLC-1 connector terminals F/P and GND. Turn ignition on for 15 seconds. Measure fuel injector volume.
  4. If injector output volume is less than 68-88 cc's, replace suspect injector, then check next injector. If injector output volume is 68-88 cc's or more, check next injector.
  5. When all injectors have been checked, reinstall all components. recheck system.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.