Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE
DTC P0108: BARO Sensor Input High: Testing
NOTE:
Record freeze frame data. Check for service bulletins and on-line information.
- Connect scan tool to DLC-2. Start engine. Check BARO V PID. If PID is more than 4.8 volts, go to next step. If PID is 4.8 volts or less, problem is intermittent. See TROUBLE SHOOTING - NO CODES article.
- Turn ignition off. Disconnect EGR boost sensor. Check EGR boost sensor connector terminals. If connectors are okay, go to next step. If connectors are faulty, repair as necessary and go to step 7 .
- Check continuity between EGR boost sensor harness connector terminal "A" (Brown/Yellow wire) and ground. See WIRING DIAGRAMS article. If continuity is present, go to next step. If continuity is not present, repair open in Brown/Yellow wire between PCM harness connector terminal No. 91 and EGR boost sensor harness connector terminal "A". See Figure . Go to step 7 .
- Disconnect PCM harness connector. PCM is mounted to passenger floor, behind glove box. Check PCM harness connector and PCM terminal No. 91. If terminal is okay, go to next step. If terminal is faulty, repair as necessary and go to step 7 .
- Check continuity between EGR boost sensor harness connector terminals "B" (Violet/Red wire) and "C" (Pink/Blue wire). If continuity is not present, go to next step. If continuity is present, repair short between circuits. Go to step 7 .
- Check continuity between EGR boost sensor harness connector terminal "B" and PCM connector terminal No. 34. If continuity is present, go to next step. If continuity is not present, repair open in Violet/Red wire between EGR boost sensor harness connector terminal "B" and PCM harness connector terminal No. 34. See Figure . Go to next step.
- Reconnect all components. Turn ignition on. Using scan tool, clear DTC. Start engine. Ensure IAT PID is more than 50°F. Ensure BARO V PID is .2-4.8 volts. Recheck DTCs. If DTC P0108 is present, replace PCM and go to next step. If DTC P0108 is not present, go to next step.
- Perform after repair procedure. See AFTER REPAIR PROCEDURE . If DTC is not present, testing is complete. If any DTC is present, go to appropriate test for diagnosis and repair.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
