2001 Mazda B2500 SE, AutomaticFACTORY OEM SERVICE PROCEDURE

System Tests (Evaporative Emissions): Notes

NOTE: Prior to performing any system test, see HOW TO USE SYSTEM TESTS  under SYSTEM TESTS. If instructed to replace Powertrain Control Module (PCM) after performing a system test, new PCM must be programmed. See PROGRAMMING PCM .

Perform these tests when instructed during QUICK TEST or if directed here from DIAGNOSTIC TROUBLE CODE DEFINITIONS . Perform appropriate system test, see EVAPORATIVE EMISSIONS DIAGNOSTIC TROUBLE CODE REFERENCE  table. For emission-related symptom tests, see TROUBLE SHOOTING - NO CODES table. For component reference, see Fig 1-Fig 3 .

EVAPORATIVE EMISSIONS DIAGNOSTIC TROUBLE CODE REFERENCE

DTC Description Go To Test
P0442 Small Leak Detected In EVAP System A 
P0455 Major Leak Or No Flow Detected In EVAP System B 
P0456 Very Small Leak Detected In EVAP System A 
P0457 Fuel Filler Cap Off A 
P1443 Very Small Or No Purge Flow Detected In EVAP System B 
P1450 Excessive Vacuum Detected In Fuel Tank C 
Fig 1: Identifying EVAP System Components (Except Tribute)
G00035643Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.