Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
OBD-II Drive Cycle Vehicle Preparation
OBD-II drive cycle procedure is designed to execute and complete OBD-II monitors and clear DTC P1000. Ensure level in fuel tank is between 1/2-3/4 full. A 3/4 full tank is preferable. Use the following procedures to complete a specific monitor and record for repair verification:
- Install scan tool. Turn ignition switch to ON position. Cycle ignition switch off, then on. Using scan tool, select vehicle and engine. Clear DTCs. See CLEARING CODES under SELF-DIAGNOSTIC SYSTEM.
- Using scan tool, select PCM PIDs: ECT, EVAPDC, FLI (if available) and TP MODE from PID/DATA MONITOR & RECORD menu. Start engine. DO NOT turn ignition switch to OFF position. Allow engine to idle for 15 seconds. Drive at 40 MPH until ECT PID is at least 170°F (77°C).
- If IAT PID is 40-100°F (4-38°C), perform appropriate MONITOR drive cycle procedure(s). See OBD-II DRIVE CYCLE PROCEDURES . If IAT PID is not 40-100°F (4-38°C), perform appropriate monitor drive cycle procedure(s), ensuring EVAP MONITOR BY-PASS drive cycle is performed to clear DTC P1000.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
