2000 Mazda MPV LXFACTORY OEM SERVICE PROCEDURE

Throttle Position (TP) Sensor Replacement

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the TP sensor connector.
  2. Remove the attaching screws.
  3. Remove the TP sensor.
  4. Verify that the throttle valve is fully closed.
  5. Catch the tang of the TB on the TP sensor plastic rotor.
  6. Position the TP sensor on the TB so that the mounting holes align.
  7. Install the attaching screws.

    Tightening torqueΒ 

    1. 1.6-2.3 N.m {16-24 kgf.cm, 14-20 in.lbf}Β 
  8. Release the throttle.
  9. Verify the TP sensor PID value. (See PCM INSPECTIONΒ .)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.