Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE
Vehicle Speed Sensor
NOTE:
On vehicles without ABS, VSS signal is input to instrument cluster, then output to PCM. On vehicles with ABS, VSS signal is sent from ABS wheel speed sensors to ABS module and then to PCM.
- Disconnect negative battery cable. Disconnect vehicle speed sensor connector. Remove vehicle speed sensor. Measure voltage between sensor terminals while rotating driven gear. See Fig 1.
- Voltage reading should fluctuate about 5 volts. If voltmeter needle does not fluctuate as specified, replace sensor. If voltmeter needle fluctuates as specified, sensor is okay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
