2000 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Ignition Switch Inspection

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION .)
  2. Disconnect the ignition switch connector.
  3. Inspect for continuity between the ignition switch terminals using an ohmmeter.
    • If not as specified, replace the ignition switch.
    Fig 1: Ignition Switch Terminal Connector Continuity
    G03639056Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.