2000 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Wiper Unit Assembly Note

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the terminals of the harness assembly are connected to the terminals of the connector as shown in the table.
    COMBINATION SWITCH CONNECTOR TERMINALS REFERENCE

    The color of assembly harness Terminal of connector
    LG AJ
    LG/R J
    G/R F
    Y/R N
    R E
    B B
    G/Y H
    G/W L
    G/B P
Chapter Navigation
Return to Chapter: Combination Switch Disassembly/Assembly
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.