2000 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Front Combination Light Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Incorrect servicing of the discharge headlights could result in electrical shock. Before servicing the discharge headlights, always refer to the Discharge Headlight Service Warnings. (See DISCHARGE HEADLIGHT SERVICE WARNINGSΒ .)
  1. Disconnect the negative battery cable.
  2. Remove the front side marker lights. (See FRONT SIDE MARKER LIGHT REMOVAL/INSTALLATIONΒ .)
  3. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
  4. Remove in the order indicated in the table.
    Fig 1: Removing Bolts And Front Combination Light With Torque Specification
    G03703267Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
  6. Adjust the headlight aiming. (See HEADLIGHT AIMINGΒ )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.