2000 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Not Reusing Windshield

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • For the areas of the sealant that are difficult to cut, use the SST  (piano wire) and follow the procedure under REUSING WINDSHIELD  .
  1. Remove the base. (See BASE REMOVAL  .)
  2. Cut out the sealant all around the glass using a sealant remover.
  3. Remove the sealant by pulling it off.
  4. Remove the windshield.
    Fig 1: Removing Windshield
    G01344282Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.