Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE
DTC P0125: Excessive Time To Enter Closed Loop: Testing
NOTE:
Ensure freeze frame data has been recorded. Check for service bulletins and on-line information.
- Connect scan tool. Clear DTC. Start engine. Warm engine to operating temperature. Check ECT PID. If PID is less than 140°F (60°C), go to next step. If PID is 140°F (60°C) or more, problem is not present. Check for intermittent problem. See TROUBLE SHOOTING - NO CODES article.
- Turn ignition off. Disconnect ECT sensor, located above starter. Check for loose, damaged or corroded terminals. If no problems are present, go to next step. If any problems are present, repair as necessary and go to step 5 .
- Check resistance between ECT sensor terminals No. 1 and No. 2. If resistance is about 2000 ohms, go to next step. If resistance is not about 2000 ohms, replace sensor and go to step 5 .
- Disconnect PCM connector. PCM is mounted to passenger floor, behind glove box. Check for loose, damaged or corroded terminals. If no problems are present, go to next step. If any problems are present, repair as necessary and go to next step.
- Reconnect all components. Turn ignition on. Using scan tool, clear DTC. Allow engine to reach ambient temperature. Ensure ECT PID is less than 68°F (20°C). Start engine and warm to operating temperature. Recheck DTCs. If DTC P0125 is pending, replace PCM and go to next step. If DTC P0125 is not pending, go to next step.
- Perform after repair procedure. See AFTER REPAIR PROCEDURE . If no DTC is present, testing is complete. If any DTC is present, go to appropriate test for diagnosis and repair.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
