Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE
Changing Keyless Control Module Id Code
NOTE:
Steps 2) and 3) must be completed within 24 seconds.
- Remove key from ignition. Close all doors and liftgate. Open driver's door. Go to next step.
- Insert key into ignition. Turn ignition switch to ON position, then back to LOCK position 3 times. Remove key from ignition. Go to next step.
- Push driver's door switch 3 times. Observe door lock actuators. They should lock, then unlock. If operation is as specified, go to step 5 . If operation is not as specified, go to next step.
- Check ROOM fuse (10-amp) and ENGINE fuse (10-amp) in underdash fuse block. Replace if necessary. If fuses are okay, wait 40 seconds and repeat steps 2 and 3 one more time. If problem is still present, go to TEST NO. 3: TRANSMITTER ID CODE CANNOT BE REPROGRAMMED under SYMPTOM TESTS.
- Aim transmitter at keyless control module. Push any button of transmitter twice. Observe door lock actuators. They should lock, then unlock. If operation is as specified, go to next step. If operation is not as specified, push driver's door switch. Actuators should lock and unlock twice. If actuators do lock and unlock twice, go back to step 2 . If actuators do not lock and unlock twice, go to TEST NO. 3: TRANSMITTER ID CODE CANNOT BE REPROGRAMMED under SYMPTOM TESTS.
- If only one transmitter is available, push any button on transmitter twice. If more than one transmitter is available, push any button on other transmitter twice. Observe door lock actuators. They should lock, then unlock. If operation is as specified, repeat this step with any other available transmitters to complete programming procedure. If operation is not as specified, push driver's door switch. Actuators should lock and unlock twice. If actuators do lock and unlock twice, go back to step 2 . If actuators do not lock and unlock twice, go to TEST NO. 3: TRANSMITTER ID CODE CANNOT BE REPROGRAMMED under SYMPTOM TESTS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.