2000 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE

Vehicle Speed Sensor

NOTE: On vehicles without ABS, VSS signal is input to instrument cluster, then output to PCM. On vehicles with ABS, VSS signal is sent from ABS wheel speed sensors to ABS module and then to PCM.
  1. Disconnect negative battery cable. Disconnect vehicle speed sensor connector. Remove vehicle speed sensor. Measure voltage between sensor terminals while rotating driven gear. See Fig 1.
  2. Voltage reading should fluctuate about 5 volts. If voltmeter needle does not fluctuate as specified, replace sensor. If voltmeter needle fluctuates as specified, sensor is okay.
Fig 1: Checking Vehicle Speed Sensor
G96C19168Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.